Originální popis anglicky:
cfsetospeed - set output baud rate
Návod, kniha: POSIX Programmer's Manual
#include <termios.h>
int cfsetospeed(struct termios *
termios_p,
speed_t speed);
The
cfsetospeed() function shall set the output baud rate stored in the
structure pointed to by
termios_p to
speed.
There shall be no effect on the baud rates set in the hardware until a
subsequent successful call to
tcsetattr() with the same
termios
structure. Similarly, errors resulting from attempts to set baud rates not
supported by the terminal device need not be detected until the
tcsetattr() function is called.
Upon successful completion,
cfsetospeed() shall return 0; otherwise, it
shall return -1 and
errno may be set to indicate the error.
The
cfsetospeed() function may fail if:
- EINVAL
- The speed value is not a valid baud rate.
- EINVAL
- The value of speed is outside the range of possible
speed values as specified in <termios.h>.
The following sections are informative.
None.
None.
Refer to
cfgetispeed() .
None.
cfgetispeed() ,
cfgetospeed() ,
cfsetispeed() ,
tcsetattr() , the Base Definitions volume of
IEEE Std 1003.1-2001, Chapter 11, General Terminal Interface,
<termios.h>
Portions of this text are reprinted and reproduced in electronic form from IEEE
Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable
Operating System Interface (POSIX), The Open Group Base Specifications Issue
6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics
Engineers, Inc and The Open Group. In the event of any discrepancy between
this version and the original IEEE and The Open Group Standard, the original
IEEE and The Open Group Standard is the referee document. The original
Standard can be obtained online at http://www.opengroup.org/unix/online.html
.